This page was exported from All The Latest MCTS Exam Questions And Answers For Free Share
[
https://www.mctsdump.com
]
Export date: Thu Mar 28 10:15:24 2024 / +0000 GMT
Kindly Remind: PassLeader have been published the newest 400-101 brain dumps with all the new updated exam questions and answers. We provide the latest version of 400-101 PDF and VCE files with up-to-date questions and answers to ensure your exam 100% pass, and you will get the free new version VCE Player along with your VCE dumps. Welcome to visit our website -- passleader.com! NEW QUESTION 1 A. Build an OSPF virtual link. Answer: C NEW QUESTION 2 A. the forwarding information base Answer: AB NEW QUESTION 3 A. Implement larger buffers. Answer: A NEW QUESTION 4 A. The fragment header is 64 bits long. Answer: AB NEW QUESTION 5 A. The bandwidth delay product is 2 Mb. Answer: AC NEW QUESTION 6 A. the transmitted octet Answer: AB NEW QUESTION 7 A. event register keyword Answer: AB NEW QUESTION 8 A. Specify the sampling interval. Answer: AB NEW QUESTION 9 A. UplinkFast Answer: D NEW QUESTION 10 A. 0185. C400. 0000 Answer: D http://www.passleader.com/400-101.html NEW QUESTION 11 A. VSS separates the control planes of the active and the standby chassis. Answer: DEF NEW QUESTION 12 A. Change the priority of switch SWA to a lower value than the default value. Answer: D NEW QUESTION 13 A. topology change bit Answer: A NEW QUESTION 14 A. IGMP filtering Answer: C NEW QUESTION 15 A. It identifies the maximum payload packet. Answer: C NEW QUESTION 16 A. Traffic from a non-source VLAN is discarded when it arrives on a source VLAN. Answer: AEF NEW QUESTION 17 A. It sends VTPv3 packets only. Answer: C NEW QUESTION 18 A. Bridge assurance must be enabled on both ends of a link. Answer: ACE NEW QUESTION 19 A. 1 Answer: A NEW QUESTION 20 A. Enter a clock rate on the DCE interface. Answer: A
Refer to the exhibit. Which action must you take to enable full reachability from router C to router D?
B. Build an OSPF sham link.
C. Configure mutual redistribution between OSPF and EIGRP on routers A and B.
D. Add a static route on router D.
Which two Cisco Express Forwarding tables are located in the data plane? (Choose two.)
B. the label forwarding information base
C. the IP routing table
D. the label information table
E. the adjacency table
Which option is the most effective action to avoid packet loss due to microbursts?
B. Install a faster CPU.
C. Install a faster network interface.
D. Configure a larger tx-ring size.
Which two statements about packet fragmentation on an IPv6 network are true? (Choose two.)
B. The identification field is 32 bits long.
C. The fragment header is 32 bits long.
D. The identification field is 64 bits long.
E. The MTU must be a minimum of 1280 bytes.
F. The fragment header is 48 bits long.
You are backing up a server with a 1 Gbps link and a latency of 2 ms. Which two statements about the backup are true? (Choose two.)
B. The default TCP send window size is the limiting factor.
C. The default TCP receive window size is the limiting factor.
D. The bandwidth delay product is 500 Mb.
E. The bandwidth delay product is 50 Mb.
Which two pieces of information does RTCP use to inform endpoint devices about the RTP flow? (Choose two.)
B. the lost packet count
C. session control function provisioning information
D. the CNAME for session participants
E. the authentication method
F. MTU size changes in the path of the flow
Which two options are required parts of an EEM policy? (Choose two.)
B. body
C. environment must defines
D. namespace import
E. entry status
F. exit status
Which two actions can you take to allow the greatest number of pertinent packets to be stored in the temporary buffer of Cisco IOS Embedded Packet Capture? (Choose two.)
B. Specify the capture buffer type.
C. Specify a reflexive ACL.
D. Specify the minimum packet capture rate.
E. Specify the packet size.
F. Store the capture simultaneously onto an external memory card as the capture occurs.
Which technology can be used to secure the core of an STP domain?
B. BPDU guard
C. BPDU filter
D. root guard
What is the destination multicast MAC address for BPDUs on the native VLAN, for a switch that is running 802.1D?
B. 0100.0CCC.CCCC
C. 0100.0CCC.CCCD
D. 0180. C200. 0000
Which three statements are true about VSS? (Choose three.)
B. Configuration changes can be made on both active and standby chassis.
C. When the VSS active chassis recovers after a failure, it initiates a switchover and takes on the active role again.
D. VSS unifies the control planes of the active and the standby chassis.
E. HSRP configuration is not required to run VSS.
F. The VSS standby chassis monitors the VSS active chassis using the VSL.
Refer to the exhibit. All switches have default bridge priorities, and originate BPDUs with MAC addresses as indicated. The numbers shown are STP link metrics.
After STP converges, you discover that traffic from switch SWG toward switch SWD takes a less optimal path. What can you do to optimize the STP tree in this switched network?
B. Change the priority of switch SWB to a higher value than the default value.
C. Change the priority of switch SWG to a higher value than the default value.
D. Change the priority of switch SWD to a lower value than the default value.
Which flag in a configuration BPDU instructs all switches to shorten their bridge table aging process from the default 300 seconds to the current forward delay value?
B. topology change acknowledgment bit
C. priority bit
D. max-age bit
Refer to the exhibit. Which technology can be used on the switch to enable host A to receive multicast packets for 239.2.2.2 but prevent host B from receiving them?
B. MLD snooping
C. IGMP snooping
D. MLD filtering
Which option describes the purpose of the PPP endpoint discriminator?
B. It notifies the peer that it prefers 12-bit sequence numbers.
C. It identifies the system attached to the link.
D. It determines whether a loopback is on the link.
Which three statements about SPAN traffic monitoring are true? (Choose three.)
B. Multiple sessions can send traffic to an individual destination port.
C. It supports up to 32 SPAN ports per switch.
D. The destination port acts as a normal switchport.
E. It supports up to 64 SPAN ports per switch.
F. Only one session can send traffic to an individual destination port.
Which option describes how a VTPv3 device responds when it detects a VTPv2 device on a trunk port?
B. It sends VTPv2 packets only.
C. It sends VTPv3 and VTPv2 packets.
D. It sends a special packet that contains VTPv3 and VTPv2 packet information.
Which three statements about bridge assurance are true? (Choose three.)
B. Bridge assurance can be enabled on one end of a link or on both ends.
C. Bridge assurance is enabled on STP point-to-point links only.
D. Bridge assurance is enabled on STP multipoint links only.
E. If a bridge assurance port fails to receive a BPDU after a timeout, the port is put into a blocking state.
F. If a bridge assurance port fails to receive a BPDU after a timeout, the port is put into an error disabled state.
What is the hop limit for an MLD message?
B. 2
C. 15
D. 255
Refer to the exhibit. Which action must you take to enable the WAN link to function properly?
B. Enter a clock rate on the DTE interface.
C. Enter a compression algorithm on both interfaces.
D. Configure both interfaces for HDLC encapsulation.
Post date: 2015-01-02 08:26:21
Post date GMT: 2015-01-02 08:26:21
Post modified date: 2015-01-02 08:26:21
Post modified date GMT: 2015-01-02 08:26:21
Powered by [ Universal Post Manager ] plugin. MS Word saving format developed by gVectors Team www.gVectors.com